Ermax 7503XX079 Notice De Montage page 4

- Take off the 6 plastic rivets located behind the headlight and the 2 plastic rivets on the underside of the motorbike.
- For the left fairing: unscrew the3 screws holding the fairing, and then pull the fairing slightly back to unclip at the
head fairing level. Pull toward you at the frame and tank level to remove it. Pay attention to disconnect the
indicator's terminal before removing the fairing.
- Disassemble the plastic rivet holding the indicator cover to have access to the 3 Phillips screws securing the
indicator. Unscrew the 3 Phillips screws and then remove the original indicator.
- Recover the 3 original silentblocs fitted on the brackets of the original indicators. Place them on the provided side
cover. Fit the blinker on the side cover. Take 3 Phillips screws securing the indicator and 3 steel washers Ø6. Put one
washer on each Phillips screw. Place the side cover on the original fairing (do not put back the plastic rivet of the
indicator over for easy access to connect the blinker).
- Replace the fairing on the motorbike. The blinker wiring can be greatly facilitated by recovering the indicator
original terminal, and by placing it on the blinker's wiring.
- Repeat the same process for the fairing on the other side, in contrast there are only two screws:
- Once both sides of the fairing back on the motorbike, replace the 8 plastic rivets beside the headlight, the 2 rivets
form the underside of the motorbike, and then tighten the 4 meter cover's screws.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
White arrow : direction where draw the fairing
and unclip at the head fairing level.
Red arrows: location of the 3 fairing holding
screws.
Green points : location of the rubber inserts. Pull
toward you to unclip.
Plastic rivet of the cover
White arrow : direction where draw the fairing
and unclip at the head fairing level.
Red arrows: location of the 2 fairing holding
screws.
Green points : location of the rubber inserts. Pull
toward you to unclip.
« CAUTION »
Rivets below
3 Phillips screws