Publicité
Les langues disponibles
Les langues disponibles
The assembly of the Ermax undertray involves the original indicators' removal.
Fitting kit
Assembly
1. Rear cover kit.
- Unscrew the 2 screws holding the rear side handles (right and left sides).
Pay attention to recover and keep the 2 spacers behind these screws.
- Take one original spacer previously recovered, one fitting bracket and on BHc screw Ø8x25. Place the screw and
the spacer on the fitting bracket as indicated on the photo below, and then fit the bracket on the motorbike at the
location indicated by the red arrow.
Fitting bracket's mounting
- Take one rear side fairing, one BHc screws Ø5x20 and one rubber washer. Place one rubber spacer on the BHc
screw Ø5x20, position the cover on the motorbike and screw. Repeat the process for the other side.
2. Front cover kit.
- The screen shall be placed in high position. Unscrew the 4 holding screws of the meter cover: remove the meter
cover.
Think to bring blinkers.
Lateral fitting screws
BHc Ø8 location
FITTING INSTRUCTIONS
ERMAX REAR AND FRONT COVER KIT
ADAPTABLE ON Z 1000 SX 2011 → ∞
- 2 BHc screws small head Ø8x25
- 6 steel washers Ø6x18
- 2 rubber washers Ø6
- 2 BHc black screws wide head Ø5x20
- 2 fitting brackets
Spacers to recover
Fitting bracket fitted
Estimated fitting time : 1h00
Publicité
