Scan Sensitivity Setting - Fm; Preset Stations; Storing Preset Stations; Recalling Preset Stations - PERFECTPRO ROCKBOX 2 Manuel De L'utilisateur

Scan sensitivity setting – FM
The radio will normally scan all stations from FM broadcasts including the weaker
signals. However, you may wish the Auto-scan to find only those stations with strong
enough signals to give good reception.
1. Press the On/Off button to turn on the radio.
2. Select the FM band by pressing the Source button.
3. Press the Menu button, the display shows "Scan setting".
4. Press the Tuning knob.
5. Rotate the Tuning knob to select between "All stations" or "Strong station" (default
is All stations).
The "Strong station" option will allow the radio to find strong signals only when
scanning.
6. Press the Tuning knob to confirm your setting. The display will return to normal
radio display.

PRESET STATIONS

Storing preset stations

There are 20 memory presets in the radio, 10 for DAB and 10 for FM. Presets are
remembered by the radio in the event of a power failure.
1. Press the On/Off button to turn on the radio.
2. Press the Source button to select the desired waveband.
3. Tune to the required station.
4. Press and hold the required Preset button until the radio beeps and shows for
example "Preset 01 Saved".
5. Repeat step 3 and 4 for the remaining presets.
6. Stations stored in the preset memories can be over-written by following the above
procedure.

Recalling preset stations

1. Press the On/Off button to turn on the radio.
2. Press the Source button to select the desired waveband.
3. Briefly Press the required Preset button, the display will show for example "Preset
01 Loaded" for a few seconds and the radio frequency.
11

BLUETOOTH MODE

Pairing Bluetooth with your mobile phone

1. Press the On/Off button to turn on the radio.
2. Select Bluetooth mode by pressing the Source button.
3. The LCD display will show "Not connected" when radio is not yet paired with your
mobile phone.
4. In your mobile phone open the Setting menu and select Bluetooth, then select "PP
RockBox 2" in the Bluetooth devices list of your mobile phone (Bluetooth
pairing instructions may vary per type of mobile phone, please check your mobile
phone manual).
5. When Bluetooth pairing is successful, the LCD display will show "BT Connected" in
the 1st line, and your mobile's name in the 2nd line for about 2 seconds.
6. Finally the LCD display will show the connected mobile phone's name in the 1st line
to indicate the connected device to the radio.

Playing music from your mobile phone

1. Press the On/Off button to turn on the radio.
2. Select Bluetooth mode by pressing the Source button.
3. Start playing music by using the media players in the paired mobile phone.
4. Playback can be controlled from the mobile phone or by pressing the
buttons (preset buttons 3, 4 and 5) on the radio.
5. After music playback starts, the name of the song will be displayed in the LCD.
Display modes – Bluetooth
In Bluetooth mode, the radio can display a range of information of the current playing
music on the display. Press the Info button to cycle through the various types.
a. Title Displays scrolling song's name of the current playback music.
b. Artist Displays the artist's name of the current playback music.
c. Album Displays the album name of current playback music.
d. Status Displays the playback status. E.g. playing, stopped.
e. Music info Displays the music format and sampling rate of current playing
song. E.g. "AAC" is the format of the song; "44100Hz" is the
sampling frequency of the song.
f. Time & date Displays the current time and date.
GB
, and
12