Freeze Mode - Rollei HS Freeze 6 Instructions

Operation
30
M (manual) Mode
1 . Enter Menu 1 and press the second function button repeatedly until the display
shows M on the LCD .
2 . Press the third function button to change the sync mode . Choose between
normal mode, high speed mode and freeze mode .
3 . Enter Menu 2 to set the channel and the group of the flash .
4 . Choose the wireless remote control mode according to the trigger that you use .
5 . In the manual mode the power can be set from 1 .0 ~ 9 .0 . The minimum power
output is 1 .0 and the maximum one is 9 .0 . For a small adjustment in increments
of 0 .1 f stop just rotate the power output knob and the value will be adjusted
accordingly . For big adjustments press the power output knob once and then
rotate it and the value will be changed by 1 f stop .
High Speed Sync
If high speed sync is activated the icon
In this sync mode you can set the shutter speed up to 1/8000s, to synchronize the
speed with the flash . The power output in this sync mode can only be set
between 4 .0 up to 9 .0 .

Freeze Mode

If the freeze mode is activated the icon
mode the maximum shutter speed is limited to the normal flash sync time (normally
1/250s), but the flash can be fired with 1/19000s . The power output in this sync
mode can be set between 1 .0 up to 9 .0 .
ENGLISH
will be shown on the display .
will be shown on the display . In this