Installing The Water Line; What You Will Need - GE GLE12HSLSS Manuel D'utilisation Et Instructions D'installation

INSTALLING THE WATER LINE

BEFORE YOU BEGIN
tubing you need. Approved plastic water supply
lines are SmartConnect™ Refrigerator Tubing
When connecting your refrigerator to a GE
Appliances Reverse Osmosis Water System, the only
manufacturer's recommendations.
refrigerator's water filtration cartridge in conjunction
with the RO filter can result in hollow ice cubes and
slower water flow from the water dispenser.
This water line installation is not warranted by
expensive water damage.
Water hammer (water banging in the pipes) in house
plumbing can cause damage to refrigerator parts and
lead to water leakage or flooding. Call a qualified
plumber to correct water hammer before installing the
water supply line to the refrigerator.
To prevent burns and product damage, do not hook
up the water line to the hot water line.
water line, make sure the icemaker power switch is in
the OFF position.
When using any electrical device (such as a power
drill) during installation, be sure the device is double
insulated or grounded in a manner to prevent the
All installations must be in accordance with local
plumbing code requirements.
WARNING
Connect to potable water supply only.
A cold water supply is required for automatic
icemaker operation. The water pressure must be
22
Accessory Installation Instructions

WHAT YOU WILL NEED

Copper or
SmartConnect™
Refrigerator Tubing kit,
connect the refrigerator to
copper, be sure both ends of the tubing are cut
square.
To determine how much tubing you need: measure
the distance from the water valve on the back of the
(2.4 m). Be sure there is sufficient extra tubing (about
diameter) to allow the refrigerator to move out from
the wall after installation.
available in the following lengths:
15'
(2.4 m) as described above.
NOTE: The only GE Appliances approved plastic
tubing is that supplied in SmartConnect™
Refrigerator Tubing kits. Do not use any other
plastic water supply line because the line is
under pressure at all times. Certain types of
plastic will crack or rupture with age and cause
water damage to your home.
A GE Appliances water supply kit (containing
tubing, shutoff valve and fittings listed below) is
available at extra cost from your dealer or from
A cold water supply. The water pressure must be
without a water filter and between 40 and 120 p.s.i.
Power drill.
Straight and Phillips blade screwdriver.
49-60769 Rev. 5