Kohler CLEARFLO 7160 Instructions D'installation page 4

ATTACHED LIFT ROD ASSEMBLY MODELS: Position
the lift rod assembly directly on the drain stopper. Adjust
the assembly length so the alignment ribs of the overflow
hood line up with the top edge of the overflow hole in the
bath. Refer to the illustration.
Insert the lift rod assembly into the overflow ell. Tighten
the overflow hood to the overflow ell with the two screws
provided.
NOTE: For installations where the overflow hood will be
exposed to high volumes of direct water spray, apply
silicone sealant around the overflow hood.
Assemble the handle to the overflow hood with the screw
provided. It may be necessary to adjust the handle to the
desired position.
Insert the drain stopper into the drain ell.
The drain stopper should rise approximately 3/8" (1cm)
above the strainer. To adjust the stopper height, remove
the stopper and loosen the nut below the stopper. Raise
the stopper by turning counterclockwise, or lower by
turning clockwise.
A
1010455-2-
Fig. #9
Fig. #10
Fig. #11
Toggle
Fig. #12
4
Alignment
Overflow
Ribs
Hole
Handle
Overflow
Hood
Stopper
Nut
Kohler Co.