Operating Instructions - skilsaw SPT55 Consignes De Fonctionnement/Sécurité

WARNING
make you careless. Remember that a
careless fraction of a second is sufficient to
inflict serious injury.
WARNING
to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could
result in objects being thrown into your eyes
and other possible serious injuries.
WARNING
not recommended by the manufacturer of
this product. The use of attachments or
PREPARE SAW FOR USE (FIG. 7)
Attach the assist handle to the mount on the
left front side of the foot.
Check the tension of the saw chain: please refer
to the CHECK/ADJUST CHAIN TENSION.
Check the chain-oil tank level and add oil if
necessary; refer to FILLING CHAIN-OIL TANK
WITH CHAIN OIL.
CUTTING WITH THE CARPENTRY
CHAINSAW (FIG. 8)
Always hold the saw by the main handle with
one hand and the auxiliary handle with the
other hand. Maintain a firm grip and stable
footing.
Make sure that the material is properly
clamped and supported off the ground. Note
that the nose cap will need room to clear the
ground or any other obstacles.
Your carpentry saw is designed mainly for
cross cutting. Some specialized cuts may
require a short rip cut.
14

Operating Instructions

Do not allow familiarity
with this product to
Always wear eye protection
with side shields marked
Do not use
attachments or accessories
accessories not recommended can result in
serious personal injury.
WARNING
damaged, missing, or loose parts, such as
screws, nuts, bolts, caps, etc. Securely
tighten all fasteners and caps and do not
operate this product until all missing or
damaged parts are replaced.
You may use this product to single cut or
any
gang cut 6X, 8X, 10X, and 12X beams,
parallel-strand lumber, glued-laminate timber,
laminated-veneer lumber, TJI I-joists, and
other large beams and lumber.
Fig. 7
Fig. 8
Before each use, inspect
the entire product for
APPLICATION