DS 60190 IN
SETTING UP AND CHANGING THE ACTIVE CARBON FILTER
This system is used in locations without ducting to the outside or when it is not possible to install such
ducting.
Disconnect the machine from the mains.
A. Remove metal filters.
B. The circular filters (Figure 2) are located at either end of the motor. Turn the carbon filters anti-clockwise
until they are unscrewed.
C. Apply reverse procedure to install the carbon filter.
Warning: the active carbon filter cannot be washed or recycled. It should be changed at least every
four months.
ELECTRICAL DIAGRAM.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage
Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
MAIN PARAMETERS
Rated Input
220V-240V, 50Hz
Rated Power
107.5W
Lighting Power
2.5WX1
Motor Power
105W
Drive Mode
Single Motor
Speed
Speed I Speed II Speed III
Air tube diameter
150MM
Air output
≥378.3m3/h
Air pressure
≥190Pa
Noise
≤68dB(A)
16