Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BILEX485 BUILT-IN INSTRUCTIONS
x6
N570-0073 (1/4-20 X 3/8")
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by
a qualified installer to local codes.
1. Attach side mounting brackets to each side of the grill using #1/4-20 x 3/8" screws (N570-0073).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied
to each wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect
the flex supply line to the fitting at the end of the manifold.
4. The entire installation must be leak tested before operating the unit.
N415-0434 NOV 13.17
19
APPLY A DAB OF SILICONE
TO EACH FLANGE TO
SECURE IN PLACE.
www.napoleongrills.com
EN
Publicité
Table des Matières
