Napoleon BILEX485 Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

the grill, but it can also be done with the burner installed. Do not flex the drill bit when drilling the ports,
as this will cause the drill bit to break. This drill is for burner ports only, not for the brass orifices (jets)
which regulate the flow into the burner. Take care not to enlarge the holes. Ensure the insect screen is
clean, tight, and free of any lint or other debris.
Reinstallation: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing.
WARNING!
important that the valve/orifice enters the burner tube before lighting your
gas grill. If the valve is not inside the burner tube a fire or explosion could
occur.
WARNING!
in the hose. If any of these conditions exist, do not use the gas grill. Have the part replaced by your
Napoleon Gas Grill dealer or qualified gas installer.
Aluminum Castings: Clean castings periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidation to occur on aluminum surfaces. This appears as white
spots on the castings. To refinish these areas, clean first and sand lightly with fine sandpaper. Wipe the
surface to remove any residue and paint with high temperature barbecue paint. Protect surrounding
areas from over-spray. Follow the manufacture's directions for curing.
N415-0434 NOV 13.17
When reinstalling the burner after cleaning it is very
Regulator Hose (when applicable): Check for abrasions', melting, cuts, and cracks
11
EN
www.napoleongrills.com

Publicité

Table des Matières
loading

Table des Matières