Options list or CAM information.
6.3. MMI menu:
It can appear a first information line followed by the list
of options with a number. The last option (0.Quit) goes
to the precedent menu. If the information to show
is longer than the display size, push
of the text.
CAM's data introduction (example
6.4. MMI Enquiry:
insert PIN). Look at point 6.5.
CAM's data introduction.
6.5. Enter User Input:
7. MEMORY
- utomatic save: 30 minutes after the last button
is pressed, the current data will be stored in the
TTT 8000.
Stores current programming.
7.1. Save Configuration:
7.2. Restore Configuration:
stored in the unit to be recovered.
7.3. Save Configuration, Device to UCF 300:
enables the configuration stored to be saved with an
identifying name in one of the 26 memories of the
UCF 300.
7.4. Load Configuration, UCF 300 to Device:
recovers the data in one of the UCF 300's memories
with data recorded from an TTT-TWIN-CI /TCT-TWIN-CI
to clone the in another module.
to read the rest
Enables the configuration
16
I
RF LEVEL DJUSTMENT
Remove the coaxial bridge from the RF channel
1.
output (8) of module 1 beside the power source.
djust the output level to 75 dBµV via UCF 300
2.
(see point 2 Programming).
Connect the 75 Ω axial bridge again.
3.
Taking the measurement at the SH or S C amplifier
4.
output, adjust the levels of the other modules so that
they are equalised to the level of module 1,
which has already been adjusted.
Adjust the amplifier gain, taking into account its
5.
maximum output level and the reduction according
to the number of the channels in the installation,
as shown in Table 3.
Tab. 3
Number of
2 4
channels COFDM
Reduction of the
maximum output
3 6
level (dB)
I
LED FUNCTIONS
Status LED:
G
Green color: Tuner tuned
G
Yellow color: Signal problems
G
– Unsyncronized tuner.
– Program not found.
– Exceeded output BW > 92%.
– Out RF: OFF.
– CAM non detected
Red color: Unit failure
G
Communication LED: Yelow: waiting for data.
G
5
6
8 16 24 32 64
7
8
9 12 16 15 18