Automatic Washing/Drying Cycle - Candy CSWS 485D/1-88 Mode D'emploi

8. AUTOMATIC WASHING/
DRYING CYCLE
You cannot exceed the maximum
dryable load of laundry indicated in
the programme table, otherwise the
laundry will not be dried satisfactory.
- Washing
l
Open the drawer and put in the correct
amount of detergent.
l
Refer to the list of washing programmes
for the fabrics to be washed (e.g. very
dirty cotton) and turn the selector knob to
the required programme.
l
Adjust the wash
necessary.
l
Press the option buttons (if required).
l
Check that the tap is turned on and that
the discharge
correctly.
- Drying
l
Select the degree of dryness that you
require:
EXTRA DRY
(suitable for towels, bathrobes and
bulky loads).
IRON DRY
(that leaves the laundry ready for
ironing).
CUPBOARD DRY
(for items that will be put away
without ironing).
By selecting the wool programme,
only the default degree of dryness is
available.
l
Press the START/PAUSE button.
temperature
hose is positioned
l
At the end of the wash phase the display
will show the drying time remaining.
l
When the programme is finished the word
"End" will appear on the display. After 5
minutes the appliance will go into
standby mode (on certain models, the
display will show two lines).
l
Switch off the machine by turning the
programme selector to the OFF position.
l
Open the door and remove the laundry.
l
Turn off the tap.
CANCELLING THE DRYING PROGRAMME
if
l
To cancel the drying programme, press
and hold the DRYING SELECTION
button for about 3 seconds.
WARNING:
After cancelling the drying programme,
the cool down phase will begin and you
must wait for about 10/20 minutes
before opening the door.
In order to ensure the correct operation
of the appliance, it is advisable not to
interrupt the drying phase unless it is
absolutely necessary.
82