Mounting - Tripp-Lite BP Serie Manuel De L'utilisateur

200801218 93-2487 BP External BP OM.qxd
Mounting (Rack)
Mount your rackmount battery pack in either a 4-post or 2-post rack or rack enclosure (see next
page for 2-post mounting). The user must determine the fitness of hardware and procedures
before mounting. If hardware and procedures are not suitable for your application, contact the
manufacturer of your rack or rack enclosure. The procedures described in this manual are for
common rack and rack enclosure types and may not be appropriate for all applications.
4-Post Mounting
Most external battery packs include the hardware required for 4-post mounting. If this hardware
did not come with your unit, an Adjustable 4-Post Rackmount Shelf Kit (Model UPSRMRII) may
be ordered separately from Tripp Lite.
Connect the two segments of each shelf
1
the included screws and nuts
screws slightly loose so that the shelves can be
adjusted in the next step.
Adjust each shelf to fit your rack, then mount
2
them in the lowest available space of your rack with
the screws, nuts and washers provided
the support ledges should face inward. Tighten
the screws that connect the shelf segments
Attach mounting ears
3
holes of your equipment
vided . The ears should face forward.
E
Using an assistant if necessary, lift your equipment
4
and slide it onto the mounting shelves. Attach your
equipment to the rack by using the appropriate
hardware through its mounting ears and into
F
the rack rails.
2/28/2008
using
A
. Leave the
B
. Note that
B
.
A
to the front mounting
C
using the screws pro-
D
3
11:42 AM Page 3
B
A
1
B
2
D
C E
3
F
4
A