Connections; Installing The Wall Mount; Installation Precautions - Samsung HW-J250 Manuel D'utilisation

Masquer les pouces Voir aussi pour HW-J250:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25

CONNECTIONS

INSTALLING THE WALL MOUNT

You can use the wall mount bracket to mount this unit on a wall.

▶ Installation Precautions

Install on a vertical wall only.
For the installation, avoid a location with high temperature or
humidity, or a wall that cannot sustain the weight of the set.
Check the strength of the wall. If the wall is not strong enough to
support the unit, reinforce the wall or install the unit on a different
wall that can support the unit's weight.
Purchase and use the fixing screws or anchors appropriate for the
kind of wall you have (plaster board, iron board, wood, etc.). If
possible, screw the support screws into wall studs.
Purchase wall mounting screws according to the type and thickness
of the wall you will mount the Soundbar on.
- Diameter : M5
- Length: 1 3/8 inches (35 mm) or longer recommended.
Connect cables from the unit to external devices before you install it
on the wall.
Make sure the unit is turned off and unplugged before you install it.
Otherwise, it may cause an electric shock.
To install the Soundbar on a wall, follow these steps:
1. Place the installation guide against the wall surface.
The installation guide must be level.
If the TV is mounted on the wall, install the Soundbar at least 2
inches (5 cm) below the TV.
2. Mark the location where the screws will go through on the wall,
and then remove the installation guide. Next, drill holes for the
screws using an appropriately sized drill bit.
3. Fasten the wall mounts and screws to the marked locations.
The left and right mounts are different shapes. Make sure to
position them correctly.
4. Secure the two holder screws to the screw holes on the back of
the Soundbar's main body, one on the left and one on the right.
5. Insert the USB cable into the back of the Soundbar before installing
it on the wall.
6. Set the holder screws on the back of the Soundbar into the grooves of the wall mounts.
For safe installation, make sure to push the holder screws all the way to the bottom of the grooves.
Wall Mounting the Soundbar
11
CONNECTIONS
2 inches
(5 cm) or more

Publicité

Table des Matières
loading

Table des Matières