Errors And Faults - Matrix Xone 20V Manuel D'utilisation

Errors and faults

UK
The device has been checked for proper
functioning several times during production.
If malfunctions occur nonetheless, check the
device according to the following list.
Troubleshooting tasks which require the housing
to be opened must only be carried out by an
authorized specialist electrical company or by
Trotec.
Slight smoke or odour are emitted during first
use:
• This is not a fault. These phenomena
disappear after a brief runtime.
The battery does not charge:
The battery does not charge:
• Check whether the battery is inserted
correctly in the quick charger.
Slide the battery into the quick charger in a
way that the battery terminals engage in the
charger. The battery must lock in place
in the charger.
• Check the power connection.
• Check the power cable and mains plug for
damages.
• Check the on-site fusing.
• Check the quick charger for damages. Should
the quick charger be damaged, stop using it.
Contact the Trotec customer service.
• Check the battery terminals for dirt. Remove
any dirt.
• The battery might be defective and have to
be replaced. Only use batteries of the same
type.
The device does not start:
• The battery power might be too low.
Recharge the battery.
• Check whether the battery is correctly
connected to the device.
Slide the battery onto the device in a way that
the battery terminals engage. The battery
must lock in place in the device.
• Check the battery terminals for dirt. Remove
any dirt.
30
Info
Wait for at least 10 minutes before
switching the device back on.
The tool is loose:
• Make sure that the tool is firmly locked in
place in the designated recesses of the tool
holder.
• Make sure that the clamping screw at the
tool holder is tightened properly.
• Make sure that the tool release lever is folded
back completely.
The saw blade experiences difficulties plunge
cutting the material to be processed or the
sawing/grinding performance is insufficient:
• Check the set oscillation rate, it must be
suitable for both the tool and the material.
• To select a higher oscillation rate, turn up the
setting wheel for oscillation rate selection.
• If the saw blade is worn, replace it with a
new one.
• Check whether the chosen tool is suitable for
the material to be processed.
The device becomes hot:
• Make sure not to exert too much pressure on
the device during grinding.
• Select a low oscillation rate by turn down the
setting wheel for oscillation rate selection (3).
• Check whether the tool is suitable for the
tasks to be carried out.
• Keep the venting slots clear to prevent the
motor from overheating.
• Wait for at least 10 minutes before switching
the device back on.
Notice
Wait for at least 3 minutes after
maintenance and repair work. Only then
switch the device back on.
Your device still does not operate correctly
after these checks?
Please contact the customer service. If necessary,
bring the device to an authorized specialist
electrical company or to Trotec for repair.