Bimar VR30 Notice D'instructions page 17

 " " "" button turns the appliance on and off by pressing it.
 " " button: cools the air and evaporates micro-particles of H²O it is
filled with: this function is most effective in drier air, and is less effective as
relative humidity increases (RH). The button starts and stops the water
pump. If the water level is below the minimum level, the "COOL" indicator
light flashes quickly and the pump will stop working after about one
minute.
 " " button operates the three speeds, the symbol corresponding to
the selected speed lights up: (LOW=min; MID=med; HIGH=max).
 " " button, see above.
" " button: timer " " button (G), sets the time of operation, after which

the unit will stop. Repeatedly press the button: each press changes the
time (from 1 hour to 12 hours with 1 hour intervals), the selected time will
light up on the control panel. To deactivate the timer, press the button
until the display time disappears.
" ": produces a flow of negative ions which neutralise positive ions

in the air, the corresponding symbol lights up when it is active.
17/48