Bimar VR30 Notice D'instructions page 16

Filters:
-
A. Rear filter (5), enclosed in a frame that can be
easily extracted by pulling the upper slot (6)
outwards. Composed of: 1 external synthetic
pre-filter, with fine meshes which traps dust,
lint, etc., and 1 internal honeycomb filter
(sprayed with water and thus cools the air that
passes through it) + 1 lower plastic tray (make
sure it is always inserted in the lower part.
B. Side filters (7): composed of 1 frame (extracted by
pulling it outwards) + 1 external pre-filter (traps
dust, lint, etc.) and + 1 internal honeycomb filter
(7a) (sprayed with water and so it cools the air
that passes through it) which is removed by
pulling it outwards.
Control panel and remote control with buttons for the following functions:The
-
fan functions are operated with both the keypad of the control panel and the
remote control which must be pointed at the front (maximum distance of
about 4m) towards the control panel.
To replace the "CR2025" battery, move the tab
to the centre (using a small screwdriver) and
simultaneously remove the battery holder.
Replace the battery (while checking correct
polarity), and close the battery holder. Remove
the battery for long periods of inactivity of the
remote control.
16/48