Bimar VR30 Notice D'instructions page 15

 Stand the appliance on a flat, horizontal and stable surface, and keep it away
from:
- heat sources (e.g. open flames, gas stoves, etc.)
- liquids (e.g. from bathtubs, showers, sinks etc.) to avoid splashing water and to
prevent it from falling into them (the appliance should be kept a minimum of 2
metres away).
- fabrics (curtains, etc.) or floating materials/particles that may block the
aspiration grid; check also that the front part is free from floating particles
(dust, etc.).
 If there is a fault or the appliance is not working correctly, switch it off and have
it checked by a qualified professional. Repairs done by an unqualified person can
be dangerous and cause the guarantee to become void.
 Be very careful when moving the tank when it contains water, and act by
gripping only the side handles; only move the appliance in a vertical position,
never bend it.
 The appliance comes with the following parts:
Side handles (2) for easy transport.
-
Water tank (10), at the bottom. To fill it: remove the water inlet nozzle (9)
-
outwards, insert demineralized water (without limescale), and free of
additives (essences, detergents, or other), without exceeding the max. level
(about 10L: running time of about 9/12 hours) or fill it below the minimum
level. To empty it, remove the plug (8).
Front grille: the upper (3a) and lower (3b) horizontal flaps can be adjusted up
-
or down manually and separately. The vertical flaps (4), automatically swivel
right and left by pressing the (E) button on the control panel or remote
control.
15/48