MS ROME Notice De Montage page 56

INSTALLATION IN THE VEHICLE
Grasp the seat body to check the
seat if it is fastened tightly or sha-
kes, meanwhile observe the ISOFIX
red/green indicator.
(There's indicator light shown at
the front of base for lst ROME PLUS
version).
If the seat shakes and the ISOFIX
connectors are pulled out, please repeat the above steps and install it again.
Squeeze the support leg
adjusting button, pull out the
support leg until it rests firmly
on the floor. Observe the ISOFIX
red/green indicator to confirm
the installation status.( There's
indicator light shown at the front
of base for last ROME PLUS version)
Press the rotating
button, adjust the seat to
sideward facing position
allow access for placing
a child from the seat unit
after the car seat is fitted.
CAUTION
Before every journey, make sure that the rotating part has been fully
engaged.
Do not drive unless the seat is in forward or rearward facing position.
CAUTION
The seat can be 360°rotated without limiting (Any angles).
(There's indicator light on for Premium/Professional/Ultimate version)
56
7.2.1. 4
7.2.1. 5
7.2.1. 6