MS ROME Notice De Montage page 52

INSTALLATION IN THE VEHICLE
Grasp the seat body to check the
seat if it is fastened tightly or shakes,
meanwhile observe the ISOFIX red/
green indicator.
(There's indicator light shown at
the front of base for last ROME PLUS
version).
If the seat shakes and the ISOFIX connectors are pulled out, please repeat
the above steps and install it again.
Squeeze the support leg 7.1.1.5
adjusting button, pull out the su-
pport leg until it rests firmly on the
floor. Observe the ISOFIX red/green
indicator to confirm the installa-
tion status. (There's indicator light
shown at the front of base for last ROME PLUS version).
Press the rotating
button, adjust the
seat to sideward
facing position allow
access for placing a
child from the seat
unit after the car seat
is fitted.
CAUTION
Before every journey, make sure that the rotating part has been fully
engaged.
Do not drive unless the seat is in forward or rearward facing position.
CAUTION
The seat can be 360°rotated without limiting (Any angles).
(There's indicator light on for last ROME PLUS version)
52
7.1.1. 4
7.1.1. 5
7.1.1. 6