Comunello Automation SALIENT Instructions D'utilisation Et D'installation page 16

CONTENTS
1 GENERAL PRESCRIPTIONS
1.1 Safety prescriptions
1.2 Installation prescriptions
1.3 Operating prescriptions
2 MODELS AND PRODUCTS DESCRIPTION
2.1 Description
2.2 Typical installation
3 PRODUCT TECHNICAL SPECIFICATIONS
4 INSTALLATION
4.1 Preliminary checks
4.2 Operating limits
4.3 Preparatory work for installation
4.4 Installing the SALIENT operator
4.4.1 Installation
4.4.2 Installation of limit stops and switches
4.4.3 Operator manual release
5 PREPARATION FOR ELECTRICAL CONNECTIONS
6 TESTING
7 PRODUCT MAINTENANCE
8 SPARE PARTS
9 DISPOSAL OF THE PRODUCT
10 WARRANTY
1 PRESCRIPTIONS
1.1 SAFETY PRESCRIPTIONS
This installation manual is addressed exclusively to
professionally skilled personnel.
Read all the instructions carefully before starting the
installation procedures. Any operations that are not
expressly set down in these instructions are to be
considered prohibited; improper use may result in
damage to the product and place persons and property
at risk.
The manufacturer declines all liability for failure to observe
best practices in gate construction and for any possible
deformation that may occur during use of the product.
Store this manual in a safe place for future reference.
The design and construction of the devices of which
model SALIENT is composed and this manual are in full
compliance with statutory legislation.
In consideration of potential hazards that may arise
during the installation and use of SALIENT, the installation
procedures must be carried out in full compliance with
the applicable laws, standards and regulations; namely:
1.2 INSTALLATION PRESCRIPTIONS
• Before starting the installation procedures make sure
you have any additional devices and materials that may
be required to complete the automation system with
SALIENT in consideration of the specific application.
• The door opener must not be used until the door has
been made safe.
• Dispose of packaging materials in compliance with
local regulations.
1.3 OPERATING PRESCRIPTIONS
• No modifications can be made to any part of the
product unless specified in this manual. Unauthorized
modification of the product is likely to lead to
16
COMUNELLO ®Copyright 2013 - All right reserved
malfunctions. The manufacturer declines all liability for
damage caused by unauthorized modifications.
• The parts of the automation system must never
be immersed in water or other liquids. During the
installation procedures ensure that no liquids penetrate
inside the control unit or other open devices.
• If liquids penetrate any parts of the automation system
disconnect the electrical power supply immediately
and consult Comunello technical service; the use of
SALIENT in such conditions may give rise to potentially
hazardous situations.
• Keep all parts of SALIENT away from heat sources
and open flames; exposure to heat or flames may
damage the devices and cause faults, fire, or
hazardous situations.
• When the equipment remains unused for a long time,
remove the optional battery and store it in a dry place
to avoid the risk of leakage of harmful substances.
• Connect the control unit exclusively to an electric
power supply line equipped with an efficient protective
earth conductor.
• Any operations that require the SALIENT operator
housing to be opened must be performed with
the control unit and the electrical power supply
disconnected; if the disconnect device is not clearly
visible from where you are working, attach a warning
notice to the effect: "WARNING - MAINTENANCE IN
PROGRESS".
• In the case of tripping of circuit breakers or blowing of
fuses, find the fault and remedy it before resetting the
circuit breaker or changing the fuse.
• If the fault cannot be remedied using the information
given in this manual, consult technical service.
2 MODELS AND PRODUCTS DESCRIPTION
2.1 DESCRIPTION
SALIENT is an electromechanical operator for up-and-over doors in residential
settings, with built-in control unit that allows the door to be operated from a
pushbutton, remote, and whenever necessary, manually using the specific release
provided.
2.2 TYPICAL INSTALLATION
C
D
B
KEY
A