AllPondSolutions AUTO-PFC-5000 Mode D'emploi page 15

3. Reduce feeding. Overfeeding introduces a lot of organic waste and is one of
the main causes for cloudy water problems.
4. Make sure to perform regular water changes, check your unit is clean and
adequate for your pond size and do not overstock it.
My filter is leaking
1. Check that the inlet/outlet caps and O-ring have been correctly assembled
and that they are hand tight. Ensure the O-rings are intact, well lubricated and
not twisted or damaged.
2. Always secure the inlet hose and outlet hose with a jubilee clip.
3. If you find that the unit is still leaking after the above checks or there is an
obvious casing crack, you will need to replace the body casing on the unit.
My Unit is Cutting Out
1. Rinse unit's foams making sure they are free of debris.
2. Inspect the quartz sleeve for hair line cracks and ensure that all O-rings are
in place and well lubricated.
No Water Is Coming Out Of The Inlet Hosetail
If the filter is not discharging any water from the inlet, this might be due to the
following:
Outlet Control Dial is set to 'clean' - make sure that the dial is turned anti-
Ÿ
clockwise and set to 'filter'.
Not connected to the mains power supply - ensure that your pond pump and
Ÿ
filter are connected to the mains power supply.
The inlet hosetail is blocked - manually clean the inlet to remove any dirt that
Ÿ
may be blocking it.