Signalmontage
1. Vor dem Einbau Signal auf Funktion prüfen.
2. Loch mit einem Durchmesser von 4 mm in
die Grundplatte bohren.
3. Kabel von oben durch das Loch stecken.
Signalfuß in das Loch einstecken.
4. Kabel anschließen.
Signal installation
1. Prior to installation, check the signal for
proper functioning.
2. Drill a hole of diameter 4 mm in the base
plate.
3. Insert cable into the hole from above.
Insert base of signal into hole.
4. Connect cable.
4 mm