Vimar by-me Eikon 20557 Mode D'emploi page 29

Example of configuring button functions using SaveProg
software:
The setting of the DEVICE call (with ID=1) on button "P4"
sends the intercom call to NO contact N° 2 to the door/
video phone where the ID code = 1 .
Deleting all settings
This procedure is recommended when you want to change
the ID of a previously programmed door phone and do not
want to save the device settings (restoring factory settings):
1) Press and hold button "R" located below the ringtone
volume trimmer (figure 2)
2) Press and hold the buttons "A" and "B" together with
button "R" .
3) Release button "R" keeping buttons "A" and "B"
pressed
4) After 2 seconds the entry phone give a long beep .
5) Release the buttons "A" and "B" .
6) Press button "C" within 2 seconds .
25 - ENGLISH