Auto Operation Setting - Danby DPA120HB1WDB Manuel D'instructions

2
1
2
1
How to use the buttons
Auto Operation
Ensure that the unit is plugged in and has power.
The OPERATION indicator will illuminate on the
display panel of the unit.
1. Press the MODE button until AUTO is selected.
2. Press the TEMP button to set the desired
temperature. The temperature can be set within a
3
range of 17°C (62°F) to 30°C (86°F) by 1°C (2°F)
increments.
3. Press the
conditioner.
NOTE
1. In the auto mode, the air conditioner can
automatically choose the mode of Cooling, Fan,
Dehumidifying by sensing the
the actual room temperature and the set
temperatrue on the remote control.
2. In the auto mode, you can't switch the fan speed.
3. If the auto mode doesn't suit you, the desired
mode can be controlled manually.
Cooling / Fan Operation
Ensure the unit is plugged in and has power.
1. Press the MODE button to select COOL,
FAN mode.
2. Press the TEMP button to set the desired
temperature. The temperature can be set within a
i w h t n i a a r
range of 17°C (62°F) to 30°C (86°F) in 1°C (2°F)
4
increments.
3
3. Press the
4 fan speeds -Auto, Low, Med, or High.
4. Press the
conditioner.
NOTE
In the FAN mode, the temperature setting is not
displayed in the remote control and you are not
able to control the room temperature either. In this
case, only step 1, 3, and 4 may be performed.
7
button to start the air
difference between
n g e f o 1 ° 7 C 6 ( ° 2 ) F
button to select one of
button to start the air
~ 3 ° 0 C 8 ( ° 6 ) F n i ° 1 C ( ° 2 ) F