Display Indicators; Advice On How To Use The Remote Controller; Remote Controller Lock; Light Function - Saunier Duval SDH 18-025 NW Mode D'emploi

7.2.2

Display Indicators

20
19
18
17
16
15
14
13
12
Fig. 7.2 Overview of the indicators.
Legend
1 TURBO indicator
2 TRANSMISSION indicator
3 FREEZE PROTECTION indicator
4 Air indicator (function not available for these models)
5 Active Ionizer indicator
6 X-FAN indicator
7 TEMPERATURE indicator
8 TIMER indicator
9 LOCK indicator
10 SWING indicator
11 TEMP indicator
12 LIGHT indicator
13 SLEEP indicator
14 HEAT MODE indicator
15 FAN MODE indicator
16 DRY MODE indicator
17 COOL MODE indicator
18 AUTO MODE indicator
19 I FEEL indicator
20 FAN SPEED indicator
SDH18-NW-U_EN - 05/14 - Saunier Duval
7.3 Advice on how to use the remote
controller
Follow the recommendations below as to how to use the remote
1
controller:
• When in use, direct the head of the signal transmitter directly
to the indoor unit receiver.
2
• Keep the distance between the transmitter and the receiver
3
within 7 m.
4
• Avoid obstacles between the transmitter and the receiver.
5
6
• If experiencing difficulties with the remote control
communicating with the indoor unit, reduce the distance
between the remote controller and the indoor unit.
7
• Do not drop, throw or hit the remote controller.
7.3.1

Remote controller lock

8
In order to lock the buttons and display of the remote controller
device:
9
• Press and hold the - & + buttons, at the same time for over
two seconds.
10
The rest of the buttons are deactivated.
11
The lock status indicator appears.
In order to deactivate the lock:
• Press and hold the - & + buttons, at the same time again.
The rest of the buttons are activated.
The lock status indicator disappears.
7.3.2

Light function

Press the LIGHT button for less than 2 seconds to light the
display of the Indoor Unit. To switch the display back off, press
the LIGHT button for less than 2 seconds once again.
7.4

Switching the unit on and off

In order to switch the unit on:
• Press the ON button on the remote controller; the unit will
start to operate.
In order to switch the unit off:
• Press the OFF button on the remote controller; the unit will
stop.
OPERATING INSTRUCTIONS
EN
- 11 -