Fitting The Drill Steel; Removing The Drill Steel - Atlas Copco BBD 94-DSI Prescriptions De Sécurité Et Instructions Pour L'opérateur

BBD 94-DSI
CAUTION Hot insertion tool
The tip of the insertion tool can become hot and
sharp when used. Touching it can lead to burns and
cuts.
Never touch a hot or sharp insertion tool.
►
► Wait until the insertion tool has cooled down before
carrying out maintenance work.
NOTICE Never cool a hot insertion tool in water, it
can result in brittleness and early failure.

Fitting the drill steel

Whenever fitting the drill steel the following
instructions must be observed:
1. Push the retainer outwards in the direction of the
arrow, until the front portion of the retainer is able
to accommodate the drill steel collar.
2. Insert the drill steel in the chuck.
3. When the drill bottoms, push back the retainer
to lock it.
© 2010 Atlas Copco Construction Tools AB | No. 9800 0679 71 | 2010-03-29
Original instructions
Safety and operating instructions

Removing the drill steel

Whenever removing the drill steel the following
instructions must be observed:
1. Push the retainer outwards in the direction of the
arrow until the drill steel collar disengages from
the front of the retainer.
2. Pull the drill steel out.
3. Push back the retainer.
17