Teka DH 80T Serie Manuel D'instructions page 10

Dear Customer,
Congratulations on your choice. We are certain
that this modern, functional and practical device
made with first rate quality materials will fully satisfy
your requirements.
Please read all the sections in this INSTRUCTION
MANUAL before using the hood for the first time
in order to obtain maximum performance from
the device and avoid faults which may arise from
incorrect use as well as minor problem solving.
For optimal performance, the external duct should
not exceed FOUR METRES, have more than two
90 ° angles and its diameter should be at least
Ø120
Safety Instructions
•Disconnect the device before
performing any work on the interior,
e.g. during cleaning or maintenance.
•The excessive accumulation of
grease in the hood and metal filters
may cause dripping and fire risks,
therefore it is necessary to wash
the inside of the hood and the metal
filters at least once a month.
•This device can be used by children
aged 8 and over and persons
with reduced physical, sensory
or mental capabilities or lack of
experience and knowledge, if they
have been given supervision or
proper training in the safe use of
the device and if they understand
the dangers involved. Children
should not play with the device.
Cleaning and maintenance should
be performed by the user and not
by unsupervised children.
•Check that the power voltage and
frequency match those indicated
on the label located on the inside
of the hood. A suitable earth must
be connected (except for Class II
devices, marked with
technical data plate).
•For installation, a connection
method isolated from the fixed
installation should be incorporated,
in accordance with installation
regulations (adjusted to the strength
to be endured and with a minimum
opening between the contacts of
3mm) under overvoltage category
III conditions, for the emergency
shutdown, cleaning
replacement. In no event should
the earth pass through this switch.
This switch can be replaced with a
plug if it is accessible in normal use.
•If the power lead is damaged it must
be replaced by the manufacturer,
its after-sales service or by qualified
personnel in order to avoid potential
danger.
•Air should not be extracted by
ducts used to expel fumes from
equipment powered by gas or other
fuels.
on the
or light