Inserting / Removing Accessories; Use - MAXXMEE WCP-06 Mode D'emploi

Multi-Chopper
not use the device if it has malfunc-
tioned, fallen or been dropped into
water. Have it checked in a specialist
workshop before using it again.
■
Do not place the device on or next to
heat sources such as hobs or ovens.
Keep naked flames away from the
device and the connecting cable.
■
Do not expose the device to extreme
temperatures, persistent moisture,
direct sunlight or impacts.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces.
■
Never place objects on the device or
the connecting cable.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
INSERTING / REMOVING
ACCESSORIES
Picture C
Mixing Container
• Inserting: Place the mixing contain-
er (3) on the motor unit (4) and twist it
clockwise until it engages in place.
• Removing: Twist the mixing container
anticlockwise until it is released. It can
then be removed.
Blade Insert
• Inserting: Once the mixing con-
tainer (3) is mounted on the motor
unit (4), plug the blade insert (2) onto
the axis in the middle of the mixing
container and twist it a little if neces-
sary. It must rest on the bottom of the
mixing container.
• Removing: Pull up the blade insert.
Lid
• Inserting: Place the lid (1) on the
mixing container (3) so that the Start
button (5) is on the right next to the
handle (6) of the mixing container, and
twist it clockwise as far as it will go.
The Start button must then be located
directly above the handle of the mix-
ing container.
• Removing: Twist the lid anticlockwise
and take it off.

USE

Thoroughly rinse all accessories before
you first use them in order to remove
possible production residues. To do this,
follow the instructions in the "Cleaning
and Storage" chapter.
Read the "Inserting / Removing Accesso-
ries" chapter.
Set­Up and Connection
Please Note!
■
Always place the device on a dry, flat
and solid surface. Never place the de-
vice on a soft surface. The ventilation
openings on the bottom of the device
must not be covered. Otherwise it
could overheat and be damaged.
■
Before foodstuffs are placed in the
mixing container, it must be mounted
on the motor unit and the blade insert
must be fitted. Otherwise the blade
insert will not lock in place, which may
result in a malfunction.
1. Place the motor unit (4) on the kitchen
unit or another dry and clean work
surface.
2. Attach the mixing container (3) on the
motor unit.
3. Plug the blade insert (2) onto the axis.
4. Make sure that the switch (7) is in
the 0 position.
EN
13