MAXXMEE WCP-06 Mode D'emploi page 12

EN
■
Do not make any modifications to the device. Also do not
replace the connecting cable yourself. If the device, the con-
necting cable or the accessories of the device are damaged,
they must be replaced by the manufacturer, customer service
department or a specialist workshop in order to avoid any
hazards.
■
The device is not designed to be operated with an external
timer or a separate remote control system.
DANGER – Danger of Electric
Shock
■
Use and store the device only in
closed rooms.
■
Do not operate or store the device in
rooms with high humidity.
■
Never immerse the motor unit and
the connecting cable in water or
other liquids and ensure that these
components cannot fall into water or
become wet.
■
If the motor unit falls into water while
it is connected to the mains power,
pull the mains plug out of the plug
socket immediately. Only after this
should you retrieve the motor unit
from the water. Have the motor unit
checked in a specialist workshop
before using it again.
■
Never touch the motor unit and the
connecting cable with wet hands
when the motor unit is connected to
the mains power.
WARNING – Danger of Fire
■
Do not operate the device in the
vicinity of combustible material. Do
not place any combustible materials
(e.g. cardboard, paper, plastic) on or
in the device.
■
Do not insert anything into the open-
ings of the device and make sure that
they do not become clogged.
■
Do not cover the device during oper-
ation.
12
WARNING – Danger of Injury
■
Keep children and animals away from
the packaging material. There is a
danger of suffocation.
■
Animals must be kept away from the
device and the connecting cable!
■
Make sure that the connecting cable
does not present a trip hazard. It may
not hang down from the surface on
which the device is placed in order to
prevent the device from being pulled
down.
NOTICE – Risk of Damage to
Material and Property
■
Only connect the device to a plug
socket that is properly installed. The
plug socket must be readily accessible
so that the connection to the mains
can quickly be isolated. The mains
voltage must match the technical data
of the device.
■
If a fault occurs during operation, pull
out the mains plug. Otherwise always
switch off the device first before the
mains plug is pulled out.
■
Always pull the mains plug and never
the mains cable when disconnecting
the device from the mains power. Do
not pull or carry the device by the
connecting cable.
■
Inspect the device for damage each
time before you use it. The device
should only be used when it is un-
damaged and in working order! Do