Troubleshooting - Senix CSP4QL-L Manuel De L'opérateur

PROBLEM
THE ENGINE WILL NOT START
The fuel tank is empty
The primer bulb was not pressed enough
The fuel is old (over 30 days)
The spark plug is fouled
THE ENGINE WILL NOT IDLE
The air filter is dirty
The fuel is old (over 30 days)
Idle speed screw needs adjustment
THE ENGINE EMITS TOO MUCH SMOKE
Too much oil in crankcase
THE ENGINE WILL NOT ACCELERATE
The fuel is old (over 30 days)
The cutting head is bound with grass
The air filter is dirty
THE ENGINE LACKS POWER OR STALLS
The fuel is old (over 30 days)
The air filter is dirty
The spark plug is fouled
GUIDE BAR AND SAW CHAIN ARE RUNNING HOT, SMOKING OR STUCK
The saw chain tension is too tight
The chain oil tank is empty
THE SAW CHAIN DOES NOT ROTATE
The saw chain tension is too tight
The guide bar and saw chain are assembled
incorrectly
The guide bar and saw chain are damaged
The drive assembly is damaged
THE SAW CHAIN ROTATES, BUT DOES NOT CUT
The saw chain is dull
The saw chain is on backwards
If further assistance is required, take the unit to a qualified service dealer.
WWW.SENIXTOOLS.COM

TROUBLESHOOTING

SOLUTION
Fill the fuel tank with fresh fuel
Press the primer bulb 10 times
Drain the fuel tank and add fresh fuel
Replace the spark plug
Clean or replace the air filter
Drain the fuel tank and add fresh fuel
Turn idle speed screw clockwise to increase idle speed
Drain engine oil and refill with correct amount of engine
lubricant
Drain the fuel tank and add fresh fuel
Stop the engine and clean the cutting head
Clean or replace the air filter
Drain the fuel tank and add fresh fuel
Clean or replace the air filter
Replace the spark plug
Adjust the saw chain tension
Refill the chain oil tank
Adjust the saw chain tension
Refer to INSTALL THE CHAIN BAR AND CHAIN
Inspect the guide bar and saw chain for damage.
Replace them if necessary
Take the unit to a qualified service dealer
Replace the saw chain or have it sharpened by an
authorized service dealer
Check and correct the saw chain direction
17