Saw Chain; Protective Clothing; Preparation - Senix CSP4QL-L Manuel De L'opérateur

WARNING:
Always position the unit on the operator's right side. The
use of the unit on the operator's left side will expose
the user to hot surfaces and can result in possible burn
injury. To avoid burns from hot surfaces, never operate
unit with the bottom of the engine above waist level.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Operation of this equipment could create sparks that
can start fires around dry vegetation. A spark arrestor
may be required. The operator should contact local
fire agencies for laws or regulations relating to fire
prevention requirements.
WARNING:
Operate this unit only in a well-ventilated outdoor area.
Carbon monoxide exhaust fumes can be lethal in a
confined area.
WARNING:
Avoid accidentally starting the unit. To avoid serious
injury, the operator and the unit must be in a stable
position when pulling the starter rope.
CAUTION:
Do not overwork yourself. Take regular breaks and
change working position to ensure you can concentrate
on the work and have full control over the product.
Maintain firm footing and balance during operation.
CAUTION:
Inspect unit before each use. Replace damaged parts.
Check for fuel leaks. Make sure all fasteners are in
place and secure.

PREPARATION

Before each use, check the following items to ensure
safe working conditions.
POLE SAW: Before beginning work, inspect the pole
saw for damage to the housing, the saw chain and the
12
guide bar. Never use a damaged machine.
OIL TANK: Check the fill level of the oil tank. Also
check whether there is sufficient oil available while
working. Never operate the saw if there is no oil or the
oil level is not visible in order to prevent damage to
the pole saw. On average, an oil filling is sufficient for
the operating time of the fuel tank (depending on the
duration of pauses and the density of the workpiece).
SAW CHAIN: Check the tension of the saw and the
condition of the blades. The sharper the saw chain is,
the easier and more manageable operations will be.
The same applies to chain tension.
Check the tension every 10 minutes of operation
to maximize safety. New saw chains in particular
are subject to changes due to the heat created by
operation.
PROTECTIVE CLOTHING: Make sure to wear the
appropriate close- fitting protective clothing such as
hainsaw-protective pants, gloves and safety shoes.
Wear a safety helmet with integrated hearing protection
and a face guard to provide protection against falling
and recoiling branches.
WWW.SENIXTOOLS.COM