Senix CSP4QL-L Manuel De L'opérateur page 10

7. If adjustments are needed, loosen the bar adjustment
locking nut one full turn.
8. To adjust the saw chain tension, turn the chain
tensioning screw. Turning the screw clockwise
increases the tension while turning it counter-
clockwise decreases tension. A properly tensioned
chain should have no sag and should only be able to
be pulled 1/8 inch (3 mm) away from the chain bar of
the saw.
9. Once the chain is properly tensioned, tighten the bar
adjustment locking nut. DO NOT over-tension the
chain: this will lead to excessive wear and reduces
the life of both the bar and chain.
CAUTION:
The saw chain must be tensioned properly in order to
ensure safe operation.
SAW CHAIN LUBRICATION
The pole saw features automatic chain lubrication.
Never operate the pole saw without saw chain oil. The
use of the pole saw without enough saw chain oil will
damage the unit.
Only use SAE300 saw chain oil. Other oils will run the
risk of damaging the unit and voiding the warranty.
Take note of temperature conditions. Using the saw
at various temperatures requires the use of differing
oils. To ensure a sufficient layer of lubricant at lower
temperatures, use liquid oil (low viscosity).
FILLING THE OIL TANK
1. Place the saw on a level surface. Clean the area
around the oil tank cap and then open it.
CAUTION:
Make sure that no dirt gets into the oil tank to prevent
clogging in the oil nozzle.
2. Fill the oil tank with 4.02 oz. (120 ml) of saw chain
and bar oil.
Oil tank cap
3. Close the oil tank cap.
10
Oil tank
ADDING/CHECKING ENGINE OIL
CAUTION:
Attempting to start the engine before it has been
properly filled with lubricant will result in equipment
failure not covered by the warranty.
Engine lubricant has a major influence on engine
performance and service life. This unit is shipped
without engine lubricant.
Always use a 4-cycle engine lubricant that meets or
exceeds the requirements for API service classification
SJ. SAE 30, 10W30, or 10W40 are all acceptable
lubricants to use in this product. Non- detergent or
2-stroke engine lubricants will damage the engine and
should not be used. Check lubricant level before each
use.
ADD ENGINE OIL: INITIAL USE
1. Unscrew the oil cap from the engine and remove.
2. Pour 60 ml of oil into the oil fill hole. Replace and
tighten the oil cap.
CHECK ENGINE OIL: BEFORE EACH USE
1. Separate the pole saw from the engine assembly.
2. Set engine assembly on a flat level surface with shaft
parallel to surface.
3. Unscrew the oil cap and remove.
4. Lubricant level should fall within the top of the oil fill
hole (the top of screw thread).
5. If level is low, add engine lubricant until the fluid level
rises to the top of oil fill hole (the top of screw thread).
NOTE: Do not overfill.
6. Replace and tighten the oil cap.
CAUTION:
Do not overfill. Overfilling the crankcase may cause
excessive smoke, oil loss, and engine damage.
WARNING:
Operation of this equipment could create sparks that
can start fires around dry vegetation. A spark arrestor
may be required. The operator should contact local
fire agencies for laws or regulations relating to fire
prevention requirements.
MAX
WWW.SENIXTOOLS.COM