Table Des Matières; Introduction; Product Description - Husqvarna HMI Manuel D'utilisation

Introduction..................................................................... 2
Safety..............................................................................3
Menu system.................................................................. 3

Product description

This operator's manual gives descriptions of the
functions of the HMI, the Human Machine Interface, for
Overview of the control panel and the display
21
9
2
20
19
1. E-track, adjustment left.
2. Warning symbols. Refer to
display on page 6 .
3. Engine or blade speed.
4. E-track reset button. *
5. E-track, position.
6. E-track, adjustment right.
7. Engage/disengage blade clutch. This function is not
standard on all product variants.
8. Blade depth stop.
9. Selection buttons.
10. Reset button for the blade depth stop. *
11. Knob for adjustment of the blade depth stop. *
2
Contents

Introduction

3
1 2
18
17
RPM
14 13
Warning symbols on the
Operation........................................................................ 6
Troubleshooting.............................................................. 9
Appendix.......................................................................16
the product. The HMI controls and monitors important
functions and setups of the product. By HMI we mean
the control panel and the display on the product.
4
5
2 6
0
15
16
DEPTH
12 11
12. Hour meter for engine operation.
13. Menu button.
14. Knob for the throttle control. *
15. Engine temperature.
16. Blade depth stop setting.
17. Current blade depth.
18. Battery voltage.
19. Button to show blade speed in rpm on the display. *
20. Button to show engine speed in rpm on the display. *
21. Water safety system.
* = Refer to the operator's manual for the product for
more information.
7
8
10
RESET
1247 - 001 - 09.07.2019
9