Husqvarna HMI Manuel D'utilisation page 14

Message on the
Fault code
display
Hydraulic lift
C1D0D15
pump
Hydraulic lift
C1D0D11
pump
Hydraulic lower-
C1D0E15
ing valve
Hydraulic lower-
C1D0E11
ing valve
E-track position
C1E0511
sensor
E-track position
C1E0512
sensor
C1F0112 E-track motor A
C1F0111 E-track motor A
C1F0212 E-track motor B
C1F0211 E-track motor B
14
DTC description
Circuit short to battery
or open
Circuit short to ground
Circuit short to battery
or open
Circuit short to ground
Circuit short to ground
Circuit short to battery
Circuit short to battery
Circuit short to ground
Circuit short to battery
Circuit short to ground
Indication on the ma-
chine
Hydraulic lift pump
can't be used for rais-
ing the blade.
Hydraulic lowering
valve can't be used for
lowering the blade.
Cutting can continue
but E-track position
can not be detected
until fault is resolved.
Cutting can continue
but E-track can not be
used for drift compen-
sation until fault is re-
solved.
Possible action
Check K6 in relay/fuse box.
Check damage to X14 con-
nector, harness to relay/fuse
box and relay/fuse box con-
nector. If found, repair and re-
start system, reset fault code.
If problem still exists, contact
your service agent for further
information.
Check that hydraulic valve is
properly connected.
Check damage to X14 con-
nector, harness and hydraulic
valve. If found, repair and re-
start system, reset fault code.
If problem still exists, contact
your service agent for further
information.
Check damage to actuator,
connector and harness. If
found, repair and restart sys-
tem, reset fault code and reca-
librate.
If problem still exists, contact
your service agent for further
information.
Disconnect E-track and reset
fault code. Press left and right
E-track button in an attempt to
control Etrack. If fault code
doesn't appear again check
damage to E-track actuator,
harness and connector. (Fault
codes C1E0511 and C1E0512
may appear instead since E-
track is not connected.)
If fault code still exists check
damage to cowling harness
and connector. If found, repair
and reset fault codes.
If problem still exists, contact
your service agent for further
information.
1247 - 001 - 09.07.2019