Bushnell DISCOVERER 78-8970 Manuel D'instructions page 9

1. After selecting the desired eyepiece, aim main telescope tube at a land-based target at least 200 yards away
(e.g. a telephone pole or building).
2. Fully extend Focusing Tube by turning Rack and Pinion Focusing Mechanism.
3. While looking through selected eyepiece (in this case the 20 mm), slowly retract Focusing Tube by turning Rack and Pinion
Focusing Mechanism until object comes into focus.
m
ATTAch remOTe cOmPuTer cONTrOLLer AND bATTery
1. Locate Remote Computer Controller and coil cord.
2. Locate Battery Door on Discoverer Computerized Star Locator Base.
3. Remove Battery Door and insert one 9V battery.
4. Replace Battery Door.
5. Attach Remote Computer Controller with coil cord to Discoverer Computerized Star Locator Base.
Look through Main Telescope Tube and establish a well-defined target. (see Focusing Telescope section)
Remove plastic insulator from between Red Dot Finderscope battery and battery clip.
Turn Red Dot Finderscope on.
Looking through Red Dot Finderscope, turn adjustment wheels until the red dot is precisely centered on the same object already
centered in Main Telescope Tube's field of view.
Now, objects located first with the Red Dot Finderscope will be centered in the field of view of the main telescope.
❂
DeTAILeD ASSembLy (cONTINueD)
m
FOcuSINg TeLeScOPe
m
ALIgNINg FINDerScOPe
neVeR look diRectly at the sun
With youR telescope
peRmanent damage to youR eyes
may occuR