ORTHOSERVICE RO+TEN lumbopull70 Mode D'emploi page 12

P U T T I N G O N T H E A P P L I A N C E F O R T H E P A T I E N T
Dorsopull74 and Lumbopull corset
1 Open the corset (make sure that the tensioning straps are pulled out to their
full length) and secure the Velcro end pieces of the corset and back brace
®
temporarily to the sides (fig. A).
2
The shoulder straps of the brace are put on in a similar way to
the carry straps of a rucksack (fig. B).
3
Put on the corset and use the middle Velcro
Note: Pull the corset tight.
4
Ensure that the central Velcro closure is positioned in the middle.
®
5
Tension the corset by pulling on the strap-pulley system using the
designated Velcro closure ends and secure these to the front adhesive
®
surface using Velcro (fig. D).
®
6
Close the shoulder straps. To do this, pull the straps outwards
and secure to the adhesive surface on the front.
closure to fasten securely (fig. C).
®
A B
C
D