Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
P U T T I N G O N T H E A P P L I A N C E F O R T H E P A T I E N T
Lumbopull70/72
1
(First time only) If prescribed by the doctor, attach the rigid lumbar pad
to the inside of the middle rear of the corset using the Velcro
2
Open the corset (make sure that the tensioning straps are pulled out to their
full length) and secure the Velcro
end pieces temporarily to the sides (fig. B).
®
3
Position the corset in such a way that the label on the inside points upwards
and, when putting on, use the centre Velcro
Note: Pull the corset tight.
4
Ensure that the central Velcro
closure is positioned in the middle.
®
5
Tension the corset by pulling on the strap-pulley system using the
designated Velcro
closure ends (fig. D) and secure these to the
®
front adhesive surface using the Velcro
closure (fig. A).
®
closure to fasten securely (fig. C).
®
(fig. E).
®
A
B
C
D
E
Publicité
Table des Matières
