Electrolux 6 GN 1/1 Installation, Utilisation Et Entretien page 25

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.3.9 PREHEATING
The oven chamber can be preheated if necessary before starting
the actual cooking cycle.
Start the oven with the chamber empty by setting:
- the desired cooking mode.
- preheating temperature on Thermostat TS.
- continuous cooking "cont" on Timer TM.
- wait for the oven chamber temperature display to show that the
preheating temperature has been reached.
- open the oven door and place the product to be cooked inside the
oven.
Important! Risk of burns.
Open the door with due care when the appliance is hot.
- Close the door and set the desired cooking time on Timer TM
and, if necessary, adust cooking temperature on Thermostat TS.
4.3.10 UTILITIES
- Switch on the oven by pressing button I.
- Set a cooking cycle for the following UTILITIES:
this is not necessary for the other utilities as they are already
specific cycles.
- Press button U (UTILITY):
- The green UTILITY LEDs will light up and one will be flashing.
- Turn the knob clockwise or counter clockwise to select the utility
required - the relative LED will flash (flashing GREEN color).
- Press button U until the flashing LED relative to the UTILITY
selected changes colour (flashing ORANGE color).
- Wait a further 5 seconds for the LEDs relative to the selected
utilities to illuminate steadily (steady ORANGE color).
- Finally, start the cycle by pressing the START/STOP button.
A complete description of the different UTILITIES available is
included in heading 3.4 SPECIAL COOKING MODES (page 20).
Note:
If the UTILITIES
are not used for 7 seconds they are
automatically cut out, signalled by the relative button switching
off.
- To cancel one of the following preset UTILITIES (ORANGE
steady):
press the U button and turn the knob to select it so that it flashes
(ORANGE flashing).
UTILITIES with cycle presetting;
U (UTILITY)
E.g.:
UTILITY selected
(flashing GREEN LED)
Press the U button again so that the UTILITY changes colour
(GREEN flashing) and is thus cancelled.
- To cancel the other UTILITIES set another cooking cycle.
In case of cycle already started, stop it, keeping the START/
STOP button pressed for 2 seconds before cancelling the UTILITY.
25
USA

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

10 gn 2/120 gn 2/1

Table des Matières