End Of Programming - Kübler 521 Mode D'emploi

4.4 Scaling factor
4.5 Decimal point
4.6 Set mode
4.7 Set value
14
It can be set from 00.0001
up to 99.9999. The
decimal point is set to 4
decimal places.
„0" won't be accepted!
The decimal point defines
the way of displaying the
count values. It does not
affect counting.
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal
places
manual set (red key) and
electrical set
no set
(red key and set input
locked)
electrical set only
manual set only
The device will be set to
the set point by pressing
set key or activating set
input.
Set value -199999...
999999 (number of
decimal places depends
on the decimal point
option)

4.8 End of programming

Programming routine will
be passed through once
again. All parameters can
be checked.
Programming routine will
be left and the new
parameters will be stored.
Afterwards the device is
ready to use.