Commissioning Of The Fixed Setpoint Controller Mmf 230.10.120 - evenes MMF 230.10.120 Manuel D'installation

8 | COMMISSIONING OF THE FIXED SETPOINT CONTROLLER MMF 230.10.120

When the fixed setpoint controller is first connected to the network, the type of the
controller, the program version and the LOGO are shown on the display. The display
then switches to the basic display. The basic display is shows the factory setting
during the first commissioning, then the last set values and settings. In order to make
new settings in the fixed setpoint controller, the manual adjustment knob must be
basic display
disassembled so that the setting buttons are accessible.
By simultaneously pushing the button (5s)
the display switches to selection mode, where an
adjustment can be made to the existing system.
(See process)
Confirming the display saves the settings which have been made.
38 FIXED SETPOINT CONTROLLER MMF 230.10.120