evenes MMF 230.10.120 Manuel D'installation page 32

6 | ASSEMBLY OF FIXED SETPOINT CONTROLLER MMF 230.10.120
The fixed setpoint controller MMF 230.10.120 may only be fixed to different
mixer makes using the attachment kit for the respective manufacturer.
Please observe the data sheet of the mixer to be installed (torque) when selecting the drive! The
attached assembly instructions are to be observed during assembly using the attachment kits for
specific manufacturers! The fixed setpoint controller is equipped with a special mounting flange.
Simple assembly of the fixed setpoint controller on the mixer or valve or disassembly without tool
assistance is possible by activating the assembly/disassembly button.
6.1 Assembly with a AMM1 construction kit (included) on heating mixers
from the construction series
EVENES Easyflow Mix,
ESBE MG Serie,
WIP, ACASO, IVAR,
Barberi, IMIT,
IMP, BRV, Hora,
Somatherm, PAW,
Valvex, Lk Armatur,
VEXVE, Seltron
IVAR, Somatherm,
Hora, Seltron
ESBE G series,
IMIT, IMP
ESBE MG series, WIP, Acaso,
Barberi, PAW, BRV, Valvex,
Evenes Easyflow Mix
M5 x 12
FIXED SETPOINT CONTROLLER MMF 230.10.120
INSTRUCTIONS
31