Let's Go Aero GearDeck H00604 Manuel Du Produit page 5

STEP 9
Attach the carabiner to the Safety Cable [R]. From
underneath the carrier, connect the carabiner end of
the Safety Cable [R] to the "1st Position" hole in the
frame of the TwinTube [A]. [Fg.12]
NOTE: The Safety Cable [R] can be secured in two
positions. Secure the Safety Cable to the first position.
For maximum installed clearance needs, the second
position may be used.
Never operate the carrier's slide-out function without the Safety Cable [R] fully secured. Failure to follow proper
STEP 10:
REQUIRED TOOL: 10MM SOCKET OR WRENCH
Place the LED Light wiring [SS]
over the wings pointing the left
and right Lights towards their
respective corners and the 4-flat
connection towards the vehicle.
Place the Tray [V] over the Wiring
[SS] and Wings [N] and line up
the holes in the tray with the holes
in the Wings.
Install a 1/4-20 Hex Head Bolt
[W] and a 1/4" x 1-1/4" Fender
Washer [Z] in each hole in the
bottom of the Tray [V] through
to the Wings [N]. Secure each
bolt to the Wing with a 1/4" Flat
Washer [Y] and a 1/4-20 Nylock
Nut [X]. [Fg. 13]
NOTE: The larger 1/4" x 1-1/4"
Fender Washer [Z] must be
installed inside of the carrier while
the smaller 1/4" Flat Washer [Y]
must be installed from underneath
the carrier. [Fg. 14 & 15]
WARNING:
procedures may result in bodily injury and property damage.
[Fg.14]
W
Z
V
[Fg.15]
N
Y
X
Page 5 of 19
1ST POSITION
R
POSITION SIDE OF
TRAY WITH TWO
HOLES CLOSEST TO
VEHICLE.
SS
[Fg.12]
A
2ND POSITION
W
Z
V
SS
N
Y
X
[Fg.13]