Rampage Products Trailview Tonneau Top Instructions D'installation page 4

Installation Steps
Insert corner piece of vertical upright into assembled front and rear
surround parts with 5 screws.
6
Install door surround base part into vertical extrusion with a self-drilling
screw.
8
Install Door surround onto the roll cage. Insert door surround knobs. Long
Rear (LR) knob at the rear. Long Front medium (LF) knob at the front and
the Small (SM) knob into the middle hole.
10
TIP: Do Not fully tighten turns knob at this time.
LF Medium
LR Long
Install vertical extrusion to upper corner part with a small turn-knob screw.
7
Repeat this section (steps 2-10) to assemble passenger's side door
surround.
Right Upright
9
Lift roll bar pad as shown for bracket clearance over the roll bar.
11
4
Right Front