Rampage Products IS-86634 Instructions D'installation

For proper use and safety, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at
Important Safety Information
• CAUTION - The Recovery Tire Repair Kit is designed as a temporary repair. Consult a local tire repair shop for repair or
replacement of the damaged tire.
• If repairing the tire while it is still on the vehicle, make sure vehicle is on level ground and secure, unable to roll.
• Tire Plugs are not designed for sidewalls or punctures greater than 1/4" - See a local tire repair shop
• Remember, tires are under pressure. Residue air can and will escape during the repair process.
• Always wear safety glasses when working with pressurized items such as tires.
Contents
NOTE: Actual product may vary from image.
• T-Handle Reamer
• T-Handle Insertion Needle
• Needle Nose Pliers
• Pencil Air Pressure Gauge
• Rubber Cement
• Folding Knife
• 4-way Valve Stem Tool
Plug Repair Steps
1
Using provided needle nose pliers, remove object that
caused puncture. Take care, especially if the tire still has
residual air pressure. Air will escape using the repair
process.
3
Insert Reamer in puncture. Cycle the reamer through the
puncture wound while twisting the reamer. This will open
the rubber slightly while repositioning the steel belts to
make room for the plug.
Installation Instructions
Recovery Tire Repair Kit
• (4) Sheets of Tire Plugs
• (2) Internal Tire Patches
• Mending Wire
• (2) Replacement Valve Stems
• Allen Wrench for T-Handles
• Carrying Case
Page 1 of 6
2
Place a small amount of rubber cement on the T-Handle
Reamer tool. The cement will act as a
during repair and help seal the puncture when it dries.
4
Thread a plug through the T-Handle Insertion Needle.
Adjust needle to middle of the plug. Flattening the end of
the plug will help get it started through the needle.
IS-86634
.
1-800-328-2409
lubricant