Rampage Products Trailview Tonneau Top Instructions D'installation page 11

Installation Steps
Assemble the brackets by sliding the plastic backing onto the metal
extrusion.
45
Install the Tailgate Bar brackets by hooking the front edge over the belt
rail sheet metal. Close the clamp with downward pressure while pulling
the backing tight. The and lock onto the underside of the tube edge.
clamp will pop and lock onto the underside of the tube edge.
47
Fit the rubber gasket onto the top of the tailgate. Push the gasket down
over the top edge of the tailgate to seal tightly. See below for proper
orientation:
49
Secure with two screws in each bracket using pre-drilled holes.
46
Slide the tailgate bar onto the rear of the tonneau cover, using the built-in
C-channel to guide it over the flap and small tube.
48
Insert the Tailgate Bar into the brackets by pushing the bar against the
brackets and rotating it towards your body.
50
11