Black & Decker FS1600 Mode D'emploi page 5

Assembling of base and stand
1. Rotate the screw in the anti-clockwise
direction and remove it from the support
tube.
2. Place the support tube onto the base and
then tighten the screw in the clockwise
direction.
3. To assemble the main unit, release a few
inches of the adjustable tube by operating
the screw.
Motor Rear guard
4. Fit the main unit on the adjustable tube and
secure it in place by tightening the screw.
Assembly of the fan
1. To install the rear guard,
remove the blade cap and
guard nut from the motor
shaft. Then attach the rear
guard by positioning it on
the location pins on the
main unit. Secure the guard on to the motor
body by fastening the guard nut, turning it
clockwise until the guard is locked into
position.
Fan blade Front guard
Finish
2. Mount the fan blade onto the motor shaft.
Fasten the blade cap by rotating it in the
anti-clockwise direction until the blade is
fixed firmly into place.
3. Open the securing clip at the bottom of the
front guard and loosen the clip screw.
Position the top clip on the uppermost part of
the rear guard. Push the top clip down and
press rim of the front guard onto the rear
guard. Close the bottom clip and tighten the
screw.
Operations
Your Fan has three speed control to keep the
desired air flow through your room
0 - Off
1 - Low
2 - Medium
3 - High
You can press the oscillating control knob down
to make the fan oscillate to position the fan in
specific direction pull the knob up.
ENGLISH
3
5