Porter Cable PCE980 Manuel D'instructions page 9

Fig. M
26
Filling and Draining the Water Reservoir
(Fig. N)
1. Plug the water reservoir drain hole
drain plug . Secure the drain plug into position
22
by tightening the attached wing nut
Figure N.
2. Slowly fill the water reservoir to the MIN fill line
prevent accidental overfilling. Do not fill above the MAX
fill line 25 . (Fig. N)
3. To drain the reservoir, place a 5 gallon (19 liter) bucket
under the drain plug.
4. Remove the drain plug by loosening the attached wing
nut and allow the water to empty into the bucket.
Fig. N
25
24
22
Making a Cut (Fig. A)
Verify the proper alignment of the cutting cart and blade
before turning the saw on.
Secure tile against the cart fence, or edge guide
the edge guide lock 8 . Always keep hands away from
the blade.
1. Pull up the on/off switch
until the stream of water completely covers the blade.
nOTE: Cutting tile without water will damage the
cutting wheel.
2. Ease the cutting cart toward the blade then slowly feed
the tile into the blade. Continue pushing until the blade
cuts completely through the tile.
3. Turn the saw off by pushing the on/off switch
4. After the blade stops, remove the tile and remnant from
the cutting cart.
1
with the
21
23 as shown in
24 , to
23
21
7 with
to turn the saw on. Wait
1
down.
1
Locking the Cutting Cart (Fig. O)
There is one locking position for the cart.
Move the cart to the lock position and lock the cart by
pushing the pin into a hole in the rail.
3
Fig. O
3
Removal and Installation of the Cutting
Cart (Fig. A, P, Q)
To Remove the Cutting Cart
1. Unlock the cutting cart stop
2. Slide the cutting cart off the tool.
Fig. P
Fig. Q
English
10 .
7