Re-Use Drain (Optional); How To End Formula - Milnor MilTouch Guide De L'opérateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Standard—Standard drain speed; cylinder turns clockwise at drain/distribution speed.
Two-Way Wash—Two-way wash speed; cylinder reverses at wash speed for additional
mechanical action during draining.
Do Not Drain—Do not drain; bath liquor is retained, as for the injection of additional chemicals
or for baths longer than the control will allow in a single step.
Stop with Fill—Stop with fill. The cylinder does not turn while filling prior to this drain, but
turns at standard drain speed during draining.
Stop with Drain—Stop with drain. The cylinder does not turn during draining.
Stop with Fill and Drain—Stop with fill and drain. The cylinder is held stationary during both
fill and drain.
RinSave—RinSave
for a fixed time. At the end of that time, the drain opens. After a fixed time at
drain/distribution speed with the drain open, the cylinder accelerates to RinSave
drain action is available only on machines with RinSave
replaced by the standard drain speed on other machines.

Re-Use Drain (Optional)

3.1.2.15.
To Sewer—Drain this bath to the sewer.
To Reuse—If machine is equipped with an optional second drain, this selection allows draining
this bath to an optional reuse tank.

How to End Formula

3.1.2.16.
Stop—Stop and require operator to cancel the signal
Reversing—Reversing at wash speed and require operator to end formula
Rotating—Rotating at wash speed and require the operator to end the formula
Tumble—Tumble at wash speed for two minutes, then sound signal
Stop + Signal—Stop and sound operator signal for two minutes, then shut off.
Reversing + Signal—Reverse at wash speed with signal sounding for two minutes, then shut off.
Rotating + Signal—Rotate at drain speed for two minutes with signal, then shut off.
Tumble + Signal—Tumble for two minutes, then tumble with signal for two minutes, then shut
off.
The cylinder turns clockwise at approximately 1G with the drain closed
—How should this formula end?
— End of BICLJP02 —
31
Chapter 3. MilTouch Wash Formulas
speed. This
software; this drain action is
PELLERIN MILNOR CORPORATION

Publicité

Chapitres

Table des Matières
loading

Table des Matières