Axis Q8665-E Guide D'installation page 17

1 Base unit
2
Network cable
3
Power cable
4
Seal
5
Wall bracket
6
Column bracket
7
Power cable
8
Network cable
9
Gaskets
6. Using a RJ45 crimp tool, strip and crimp the network cable according to the
manufacturer's instructions.
7. Connect the network cable to the network connector on the base unit.
Note
To make the installation easier, it is possible to remove the power connector block from the
circuit board and mount it when the cables are correctly connected.
8. Connect the power cable to the power connector on the base unit. Make sure the
green/yellow ground wire is connected to the middle pin.
AXIS Q8665–E PTZ Network Camera
1
2
3
4
5
17
7
2
WARNING
6
8
9